I conducted volatile-saturated experiments in six mafic magma compositions at pressures between 400 MPa and 600 MPa to investigate the influence of alkali elements (sodium and potassium) on volatile solubility. The experiments show that existing volatile solubility models do not accurately describe CO2 solubility at mid-crustal depths. I calculate thermodynamic fits for solubility in each composition and calibrate a general thermodynamic model for application to other mafic magmas. The model shows that the relative percent abundances of sodium, calcium, and potassium have the greatest influence on CO2 solubility in mafic magmas.
I analyzed olivine-hosted melt inclusions (MIs) from Sunset Crater to investigate pre-eruptive volatiles. I compared the early fissure activity to the sub-Plinian eruptive phases. The MIs are similar in major element and volatile composition suggesting a relatively homogeneous magma. The H2O content is relatively low (~1.2 wt%), whereas the dissolved CO2 content is high (~2300 ppm). I explored rehomogenization and Raman spectroscopy to quantify CO2 abundance in MI vapor bubbles. Calculations of post-entrapment bubble growth suggest that some MI bubbles contain excess CO2. This implies that the magma was volatile-saturated and MIs trapped exsolved vapor during their formation. The total volatile contents of MIs, including bubble contents but excluding excess vapor, indicate pre-eruptive magma storage from 10 km to 18 km depth.
The high CO2 abundance found in Sunset Crater MIs allowed the magma to reach volatile-saturation at mid-crustal depths and generate overpressure, driving rapid ascent to produce the explosive eruption. The similarities in MIs and volatiles between the fissure eruption and the sub-Plinian phases indicate that shallow-level processes also likely influenced the final eruptive behavior.
The application of high-resolution (see Appendix C) energy spectrum calibrations to natural ilmenite led to the investigation of zirconium (90Zr+) and niobium (93Nb+) as potential indicators of sample ƒO2. Energy spectrum measurements were performed on an array of ilmenite crystals from the earth’s upper mantle retrieved from kimberlites and from a reduced meteorite. In all studied materials, variability in the peak shape and width of the energy spectra has been correlated with inferred sample ƒO2. The best descriptor of this relationship is the full-width at half-maximum (FWHM; see Appendix C) of the energy spectra for each sample. It has been estimated that a 1eV change in the FWHM of 93Nb+ energy spectra is roughly equivalent to 1 log unit ƒO2. Simple estimates of precision suggest the FWHM values can be trusted to 1eV and sample ƒO2 can be predicted to ±1 log unit, assuming the temperature of formation is known.
The work of this thesis also explores the applicability of this technique beyond analysis of semi-pure metals and ilmenite crystals from kimberlites. This technique was applied to titanium oxides experimentally formed at known ƒO2 as well as an ilmenite crystal that showed compositional variations across the grain (i.e., core to rim chemical variations). Analyses of titanium oxides formed at known ƒO2 agree with the estimation that 1 eV change in the FWHM of 93Nb+ is equivalent to ~1 log unit ƒO2 (in all cases but one); this is also true for analyses of a natural ilmenite crystal with compositional variations across the grain.
NASA’s Genesis mission collected SW samples for terrestrial analysis to create a baseline of solar chemical abundances based on direct measurement of solar material. Traditionally, solar abundances are estimated using spectroscopic or meteoritic data. This study measured bulk SW Na and K in two different Genesis SW collector materials (diamond-like carbon (DlC) and silicon) for comparison with these other solar references. Novel techniques were developed for Genesis DlC analysis. Solar wind Na fluence measurements derived from backside depth profiling are generally lower in DlC than Si, despite the use of internal standards. Nevertheless, relative to Mg, the average SW Na and K abundances measured in Genesis wafers are in agreement with solar photospheric and CI chondrite abundances, and with other SW elements with low first ionization potential (within error). The average Genesis SW Na and K fluences are 1.01e11 (+9e09, -2e10) atoms/cm2 and 5.1e09 (+8e08, -8e08) atoms/cm2, respectively. The errors reflect average systematic errors. Results have implications for (1) SW formation models, (2) cosmochemistry based on solar material rather than photospheric measurements or meteorites, and (3) the accurate measurement of solar wind ion abundances in Genesis collectors, particularly DlC and Si.
Deep focus earthquakes have been attributed to rapid transformation of metastable olivine within the mantle transition zone (MTZ). However, the presence of H2O acts to overcome metastability, promoting phase transformation in olivine, so olivine must be relatively anhydrous (<75 ppmw) to remain metastable to depth. A microtextural analysis of olivine phase transformation products was conducted to test the feasibility for subducting olivine to persist metastably to the MTZ. Transformation (as intracrystalline or rim nucleation) shifts from ringwoodite to ringwoodite-wadsleyite nucleation with decreasing H2O content within olivine grains. To provide accurate predictions for olivine metastability at depth, olivine transformation models must reflect how changing H2O distributions lead to complex changes in strain and reaction rates within different parts of a transforming olivine grain.
Many lunar impact melt rocks are complex mixtures of glassy and crystalline “melt” materials and inherited clasts of pre-impact minerals and rocks. If analyzed in bulk, these samples can yield complicated incremental release 40Ar/39Ar spectra, making it challenging to uniquely interpret impact ages. Here, I have used a combination of high-spatial resolution 40Ar/39Ar geochronology and thermal-kinetic modeling to gain new insights into the impact histories recorded by such lunar samples.
To compare my data to those of previous studies, I developed a software tool to account for differences in the decay, isotopic, and monitor age parameters used for different published 40Ar/39Ar datasets. Using an ultraviolet laser ablation microprobe (UVLAMP) system I selectively dated melt and clast components of impact melt rocks collected during the Apollo 16 and 17 missions. UVLAMP 40Ar/39Ar data for samples 77135, 60315, 61015, and 63355 show evidence of open-system behavior, and provide new insights into how to interpret some complexities of published incremental heating 40Ar/39Ar spectra. Samples 77115, 63525, 63549, and 65015 have relatively simple thermal histories, and UVLAMP 40Ar/39Ar data for the melt components of these rocks indicate the timing of impact events—spanning hundreds of millions of years—that influenced the Apollo 16 and 17 sites. My modeling and UVLAMP 40Ar/39Ar data for sample 73217 indicate that some impact melt rocks can quantitatively retain evidence for multiple melt-producing impact events, and imply that such polygenetic rocks should be regarded as high-value sampling opportunities during future exploration missions to cratered planetary surfaces. Collectively, my results complement previous incremental heating 40Ar/39Ar studies, and support interpretations that the Moon experienced a prolonged period of heavy bombardment early in its history.
Most asteroids originated in larger parent bodies that underwent accretion and heating during the first few million years of the solar system. We investigated the parent body of S-type asteroid 25143 Itokawa by developing a computational model which can approximate the thermal evolution of an early solar system body. We compared known constraints on Itokawa’s thermal history to simulations of its parent body and constrained its time of formation to between 1.6 and 2.5 million years after the beginning of the solar system, though certain details could allow for even earlier or later formation. These results stress the importance of precise data required of the material properties of asteroids and meteorites to place better constraints on the histories of their parent bodies. Additional mathematical and computational details are discussed, and the full code and data is made available online.