Matching Items (2)
Description
The effect of earthquake-induced liquefaction on the local void ratio distribution of cohesionless soil is evaluated using x-ray computed tomography (CT) and an advanced image processing software package. Intact, relatively undisturbed specimens of cohesionless soil were recovered before and after liquefaction by freezing and coring soil deposits created by pluviation and by sedimentation through water. Pluviated soil deposits were liquefied in the small geotechnical centrifuge at the University of California at Davis shared-use National Science Foundation (NSF)-supported Network for Earthquake Engineering Simulation (NEES) facility. A soil deposit created by sedimentation through water was liquefied on a small shake table in the Arizona State University geotechnical laboratory. Initial centrifuge tests employed Ottawa 20-30 sand but this material proved to be too coarse to liquefy in the centrifuge. Therefore, subsequent centrifuge tests employed Ottawa F60 sand. The shake table test employed Ottawa 20-30 sand. Recovered cores were stabilized by impregnation with optical grade epoxy and sent to the University of Texas at Austin NSF-supported facility at the University of Texas at Austin for high-resolution CT scanning of geologic media. The local void ratio distribution of a CT-scanned core of Ottawa 20-30 sand evaluated using Avizo® Fire, a commercially available advanced program for image analysis, was compared to the local void ratio distribution established on the same core by analysis of optical images to demonstrate that analysis of the CT scans gave similar results to optical methods. CT scans were subsequently conducted on liquefied and not-liquefied specimens of Ottawa 20-30 sand and Ottawa F60 sand. The resolution of F60 specimens was inadequate to establish the local void ratio distribution. Results of the analysis of the Ottawa 20-30 specimens recovered from the model built for the shake table test showed that liquefaction can substantially influence the variability in local void ratio, increasing the degree of non-homogeneity in the specimen.
ContributorsGutierrez, Angel (Author) / Kavazanjian, Edward (Thesis advisor) / Houston, Sandra (Committee member) / Zapata, Claudia (Committee member) / Arizona State University (Publisher)
Created2013
Description
The goal of this paper is to discuss the most efficient method to achieve early detection in lung cancers by reducing the occurrences of false-positive readings. Imaging techniques (computed tomography screenings) have greater impact than non-imaging techniques in early detection for lung cancer. On the other hand, positron emission tomography and non-imaging techniques, such as liquid biopsy, are better at distinguishing cancer stages. Therefore, these techniques are not suitable early detection methods for lung cancer. Based on literature reviews, the combination that is most capable of early lung cancer detection incorporate low-dose computed tomography screenings, thin-section computed tomography screenings, and computer-aided diagnosis. Low-dose computed tomography screenings has lower radiation-associated risks compared to the standard-dose computed tomography. This technique can be used as both at the first examination and the follow-up examinations. Thin-section computed tomography screenings can be used as a supplement to check if there is any nodules that have not yet been discovered. Computer-aided diagnosis is an add-on method to make sure the computed tomography screenings images are being correctly labeled. Identifying other contributing factors to the effectiveness of the early lung cancer detection, such as the amount of forced expiratory volume, forced vital capacity, and the presence of emphysema, could also decrease the percentage of false positive outcomes.
ContributorsChuang, Hao-Yun (Author) / Johnston, Stephen (Thesis director) / Peterson, Milene (Committee member) / School of Life Sciences (Contributor) / Barrett, The Honors College (Contributor)
Created2019-05