The honors thesis presented in this document describes an extension to an electrical engineering capstone project whose scope is to develop the receiver electronics for an RF interrogator. The RF interrogator functions by detecting the change in resonant frequency of (i.e, frequency of maximum backscatter from) a target resulting from an environmental input. The general idea of this honors project was to design three frequency selective surfaces that would act as surrogate backscattering or reflecting targets that each contains a distinct frequency response. Using 3-D electromagnetic simulation software, three surrogate targets exhibiting bandpass frequency responses at distinct frequencies were designed and presented in this thesis.

This creative project is a part of the work being done as a Senior Design Project in which an autonomous solar charge controller is being developed. The goal of this project is to design and build a prototype of an autonomous solar charge controller that can work independently of the power grid. This solar charge controller is being built for a community in Monument Valley, Arizona who live off grid. The controller is designed to step down power supplied by an array of solar panels to charge a 48V battery and supply power to an inverter. The charge controller can implement MPPT (Maximum Power Point Tracking) to charge the battery and power the inverter, it also is capable of disconnecting from the battery when the battery is fully charged and reconnecting when it detects that the battery has discharged. The charge controller can also switch from supplying power to the inverter from the panel to supplying power from the battery at low sun or night. These capabilities are not found in solar charge controllers that are on the market. This project aims to achieve all these capabilities and provide a solution for the problems being faced by the current solar charge controller

This thesis details the design process of a variable gain amplifier (VGA) based circuit which maintains a consistent output power over a wide range of input power signals. This effect is achieved by using power detection circuitry to adjust the gain of the VGA based on the current input power so that it is amplifier to a set power level. The paper details the theory behind this solutions as well as the design process which includes both simulations and physical testing of the actual circuit. It also analyses results of these tests and gives suggestions as to what could be done to further improve the design. The VGA based constant output power solution was designed as a section of a larger circuit which was developed as part of a senior capstone project, which is also briefly described in the paper.