Matching Items (2)
Filtering by
- All Subjects: Plastics
- All Subjects: Polymers--Deterioration.
- Creators: Burke, Rebekah
Description
This project is focused on local scale sustainability. The goal is to understand the impact of small unsustainable actions of people, and hopefully create a change in their habits. The focus was plastic usage, such as the use of water bottles, grocery bags, or even the packaging that our food and other products typically come in. Plastic has become an integral part of lives, where we do not even think of our actions as we stuff our leftover grocery bags in its designated drawer. My goal throughout this project was to guide people to an environmentally conscious lifestyle by increasing the likelihood of recycling on the ASU campus. I created an interactive informative presentation that focused on recycling and preventing plastic and unwanted trash from ending up in landfills and oceans. The presentation was given to a small group of participants along with two surveys. There was a survey provided before the presentation to gauge a participant's present recycling habits then there was a survey that was given some time after the presentation to track if certain recycling habits had changed due to the presentation. The post presentation survey did report that there were changes to some of the participants' recycling habits. The research provides suggestions to help increase recycling and waste prevention based off surveys that were widely distributed on campus. The top three suggestions that would help make recycling more prevalent on campus are: education on the subject, more accessibility to recycling bins, and creating an incentive program.
ContributorsVazquez, Juliana Evone (Author) / Parrish, Kristen (Thesis director) / Burke, Rebekah (Committee member) / Civil, Environmental and Sustainable Engineering Program (Contributor) / School of Sustainability (Contributor) / Barrett, The Honors College (Contributor)
Created2017-12
Description
With the growing popularity of 3d printing in recreational, research, and commercial enterprises new techniques and processes are being developed to improve the quality of parts created. Even so, the anisotropic properties is still a major hindrance of parts manufactured in this method. The goal is to produce parts that mimic the strength characteristics of a comparable part of the same design and materials created using injection molding. In achieving this goal the production cost can be reduced by eliminating the initial investment needed for the creation of expensive tooling. This initial investment reduction will allow for a wider variant of products in smaller batch runs to be made available. This thesis implements the use of ultraviolet (UV) illumination for an in-process laser local pre-deposition heating (LLPH). By comparing samples with and without the LLPH process it is determined that applied energy that is absorbed by the polymer is converted to an increase in the interlayer temperature, and resulting in an observed increase in tensile strength over the baseline test samples. The increase in interlayer bonding thus can be considered the dominating factor over polymer degradation.
ContributorsKusel, Scott Daniel (Author) / Hsu, Keng (Thesis advisor) / Sodemann, Angela (Committee member) / Kannan, Arunachala M (Committee member) / Arizona State University (Publisher)
Created2017