ASU Scholarship Showcase

Black phosphorus attracts enormous attention as a promising layered material for electronic, optoelectronic and thermoelectric applications. Here we report large anisotropy in in-plane thermal conductivity of single-crystal black phosphorus nanoribbons along the zigzag and armchair lattice directions at variable temperatures. Thermal conductivity measurements were carried out under the condition of steady-state longitudinal heat flow using suspended-pad micro-devices. We discovered increasing thermal conductivity anisotropy, up to a factor of two, with temperatures above 100 K. A size effect in thermal conductivity was also observed in which thinner nanoribbons show lower thermal conductivity. Analysed with the relaxation time approximation model using phonon dispersions obtained based on density function perturbation theory, the high anisotropy is attributed mainly to direction-dependent phonon dispersion and partially to phonon–phonon scattering. Our results revealing the intrinsic, orientation-dependent thermal conductivity of black phosphorus are useful for designing devices, as well as understanding fundamental physical properties of layered materials.

Background: Many studies used the older ActiGraph (7164) for physical activity measurement, but this model has been replaced with newer ones (e.g., GT3X+). The assumption that new generation models are more accurate has been questioned, especially for measuring lower intensity levels. The low-frequency extension (LFE) increases the low-intensity sensitivity of newer models, but its comparability with older models is unknown. This study compared step counts and physical activity collected with the 7164 and GT3X + using the Normal Filter and the LFE (GT3X+N and GT3X+LFE, respectively).

Findings: Twenty-five adults wore 2 accelerometer models simultaneously for 3Âdays and were instructed to engage in typical behaviors. Average daily step counts and minutes per day in nonwear, sedentary, light, moderate, and vigorous activity were calculated. Repeated measures ANOVAs with post-hoc pairwise comparisons were used to compare mean values. Means for the GT3X+N and 7164 were significantly different in 4 of the 6 categories (p < .05). The GT3X+N showed 2041 fewer steps per day and more sedentary, less light, and less moderate than the 7164 (+25.6, -31.2, -2.9 mins/day, respectively). The GT3X+LFE showed non-significant differences in 5 of 6 categories but recorded significantly more steps (+3597 steps/day; p < .001) than the 7164.

Conclusion: Studies using the newer ActiGraphs should employ the LFE for greater sensitivity to lower intensity activity and more comparable activity results with studies using the older models. Newer generation ActiGraphs do not produce comparable step counts to the older generation devices with the Normal filter or the LFE.

Background: An online version of the Microscale Audit of Pedestrian Streetscapes (Abbreviated) tool was adapted to virtually audit built environment features supportive of physical activity. The current study assessed inter-rater reliability of MAPS Online between in-person raters and online raters unfamiliar with the regions.

Methods: In-person and online audits were conducted for a total of 120 quarter-mile routes (60 per site) in Phoenix, AZ and San Diego, CA. Routes in each city included 40 residential origins stratified by walkability and SES, and 20 commercial centers. In-person audits were conducted by raters residing in their region. Online audits were conducted by raters in the alternate location using Google Maps (Aerial and Street View) images. The MAPS Abbreviated Online tool consisted of four sections: overall route, street segments, crossings and cul-de-sacs. Items within each section were grouped into subscales, and inter-rater reliability (ICCs) was assessed for subscales at multiple levels of aggregation.

Results: Online and in-person audits showed excellent agreement for overall positive microscale (ICC = 0.86, 95% CI [0.80, 0.90]) and grand scores (ICC = 0.93, 95% CI [0.89, 0.95]). Substantial to near-perfect agreement was found for 21 of 30 (70%) subscales, valence, and subsection scores, with ICCs ranging from 0.62, 95% CI [0.50, 0.72] to 0.95, 95% CI [0.93, 0.97]. Lowest agreement was found for the aesthetics and social characteristics scores, with ICCs ranging from 0.07, 95% CI [−0.12, 0.24] to 0.27, 95% CI [0.10, 0.43].

Conclusions: Results support use of the MAPS Abbreviated Online tool to reliably assess microscale neighborhood features that support physical activity and may be used by raters residing in different geographic regions and unfamiliar with the audit areas.

Modulated reflectance (contactless electroreflectance (CER), photoreflectance (PR), and piezoreflectance (PzR)) has been applied to study direct optical transitions in bulk MoS₂, MoSe₂, WS₂, and WSe₂. In order to interpret optical transitions observed in CER, PR, and PzR spectra, the electronic band structure for the four crystals has been calculated from the first principles within the density functional theory for various points of Brillouin zone including K and H points. It is clearly shown that the electronic band structure at H point of Brillouin zone is very symmetric and similar to the electronic band structure at K point, and therefore, direct optical transitions at H point should be expected in modulated reflectance spectra besides the direct optical transitions at the K point of Brillouin zone. This prediction is confirmed by experimental studies of the electronic band structure of MoS₂, MoSe₂, WS₂, and WSe₂ crystals by CER, PR, and PzR spectroscopy, i.e., techniques which are very sensitive to critical points of Brillouin zone. For the four crystals besides the A transition at K point, an A_H transition at H point has been observed in CER, PR, and PzR spectra a few tens of meV above the A transition. The spectral difference between A and A_H transition has been found to be in a very good agreement with theoretical predictions. The second transition at the H point of Brillouin zone (B_H transition) overlaps spectrally with the B transition at K point because of small energy differences in the valence (conduction) band positions at H and K points. Therefore, an extra resonance which could be related to the B_H transition is not resolved in modulated reflectance spectra at room temperature for the four crystals.

The valley degree of freedom in two-dimensional (2D) crystals recently emerged as a novel information carrier in addition to spin and charge. The intrinsic valley lifetime in 2D transition metal dichalcogenides (TMD) is expected to be markedly long due to the unique spin-valley locking behavior, where the intervalley scattering of the electron simultaneously requires a large momentum transfer to the opposite valley and a flip of the electron spin. However, the experimentally observed valley lifetime in 2D TMDs has been limited to tens of nanoseconds thus far. We report efficient generation of microsecond-long-lived valley polarization in WSe₂/MoS₂ heterostructures by exploiting the ultrafast charge transfer processes in the heterostructure that efficiently creates resident holes in the WSe₂ layer. These valley-polarized holes exhibit near-unity valley polarization and ultralong valley lifetime: We observe a valley-polarized hole population lifetime of more than 1 μs and a valley depolarization lifetime (that is, intervalley scattering lifetime) of more than 40 μs at 10 K. The near-perfect generation of valley-polarized holes in TMD heterostructures, combined with ultralong valley lifetime, which is orders of magnitude longer than previous results, opens up new opportunities for novel valleytronics and spintronics applications.

The strong light-matter interaction and the valley selective optical selection rules make monolayer (ML) MoS₂ an exciting 2D material for fundamental physics and optoelectronics applications. But, so far, optical transition linewidths even at low temperature are typically as large as a few tens of meV and contain homogeneous and inhomogeneous contributions. This prevented in-depth studies, in contrast to the better-characterized ML materials MoSe₂ and WSe₂. In this work, we show that encapsulation of ML MoS₂ in hexagonal boron nitride can efficiently suppress the inhomogeneous contribution to the exciton linewidth, as we measure in photoluminescence and reflectivity a FWHM down to 2 meV at T = 4 K. Narrow optical transition linewidths are also observed in encapsulated WS₂, WSe₂, and MoSe₂ MLs. This indicates that surface protection and substrate flatness are key ingredients for obtaining stable, high-quality samples. Among the new possibilities offered by the well-defined optical transitions, we measure the homogeneous broadening induced by the interaction with phonons in temperature-dependent experiments. We uncover new information on spin and valley physics and present the rotation of valley coherence in applied magnetic fields perpendicular to the ML.

Background: Public parks can be an important setting for physical activity promotion, but to increase park use and the activity levels of park users, the crucial attributes related to active park use need to be defined. Not only user characteristics and structural park attributes, but also characteristics of the surrounding neighborhood are important to examine. Furthermore, internationally comparable studies are needed, to find out if similar intervention strategies might be effective worldwide. The main aim of this study was to examine whether the overall number of park visitors and their activity levels depend on study site, neighborhood walkability and neighborhood income.

Methods: Data were collected in 20 parks in Ghent, Belgium and San Diego, USA. Two trained observers systematically coded park characteristics using the Environmental Assessment of Public Recreation Spaces (EAPRS) tool, and park user characteristics using the System for Observing Play and recreation in Communities (SOPARC) tool. Multilevel multiple regression models were conducted in MLwiN 2.25.

Results: In San Diego parks, activity levels of park visitors and number of vigorously active visitors were higher than in Ghent, while the number of visitors walking and the overall number of park visitors were lower. Neighborhood walkability was positively associated with the overall number of visitors, the number of visitors walking, number of sedentary visitors and mean activity levels of visitors. Neighborhood income was positively associated with the overall number of visitors, but negatively with the number of visitors being vigorously active.

Conclusions: Neighborhood characteristics are important to explain park use. Neighborhood walkability-related attributes should be taken into account when promoting the use of existing parks or creating new parks. Because no strong differences were found between parks in high- and low-income neighborhoods, it seems that promoting park use might be a promising strategy to increase physical activity in low-income populations, known to be at higher risk for overweight and obesity.

Plasmonic and metamaterial based nano/micro-structured materials enable spectrally selective resonant absorption, where the resonant bandwidth and absorption intensity can be engineered by controlling the size and geometry of nanostructures. Here, we demonstrate a simple, lithography-free approach for obtaining a resonant and dynamically tunable broadband absorber based on vanadium dioxide (VO2) phase transition. Using planar layered thin film structures, where top layer is chosen to be an ultrathin (20 nm) VO2 film, we demonstrate broadband IR light absorption tuning (from similar to 90% to similar to 30% in measured absorption) over the entire mid-wavelength infrared spectrum. Our numerical and experimental results indicate that the bandwidth of the absorption bands can be controlled by changing the dielectric spacer layer thickness. Broadband tunable absorbers can find applications in absorption filters, thermal emitters, thermophotovoltaics, and sensing.