2024-06-17T20:49:38Zhttps://keep.lib.asu.edu/oai/requestoai:keep.lib.asu.edu:node-1522542021-08-30T18:37:22Zoai_pmh:alloai_pmh:repo_items152254
https://hdl.handle.net/2286/R.I.20884
http://rightsstatements.org/vocab/InC/1.0/
All Rights Reserved
2013
xi, 154 p. : ill. (some col.)
Masters Thesis
Academic theses
Text
eng
Kexiang
Shah, Jami
Davidson, Joseph
Trimble, Steve
Arizona State University
Partial requirement for: M.S., Arizona State University, 2013
Includes bibliographical references (p. 110-114)
Field of study: Mechanical engineering
The friction condition is an important factor in controlling the compressing process in metalforming. The friction calibration maps (FCM) are widely used in estimating friction factors between the workpiece and die. However, in standard FEA, the friction condition is defined by friction coefficient factor (µ), while the FCM is used to a constant shear friction factors (m) to describe the friction condition. The purpose of this research is to find a method to convert the m factor to u factor, so that FEA can be used to simulate ring tests with µ. The research is carried out with FEA and Design of Experiment (DOE). FEA is used to simulate the ring compression test. A 2D quarter model is adopted as geometry model. A bilinear material model is used in nonlinear FEA. After the model is established, validation tests are conducted via the influence of Poisson's ratio on the ring compression test. It is shown that the established FEA model is valid especially if the Poisson's ratio is close to 0.5 in the setting of FEA. Material folding phenomena is present in this model, and µ factors are applied at all surfaces of the ring respectively. It is also found that the reduction ratio of the ring and the slopes of the FCM can be used to describe the deformation of the ring specimen. With the baseline FEA model, some formulas between the deformation parameters, material mechanical properties and µ factors are generated through the statistical analysis to the simulating results of the ring compression test. A method to substitute the m factor with µ factors for particular material by selecting and applying the µ factor in time sequence is found based on these formulas. By converting the m factor into µ factor, the cold forging can be simulated.
Mechanical Engineering
Metal-work
Friction
Experimental Design
Finite element method
FE simulation based friction coefficient factors for metal forming